Rear wall made of siding for installation in a SKAN HOLZ carport
Siding consists of two layers of loose 20 mm thick formwork boards, which are only attached once the carport is completely assembled. It provides increased stability, privacy from the side and protection from e.g. wind or overgrown hedges.
Product features
- Width: 352 cm
- Height: 180 cm
- Formwork thickness: 2 x 12 cm
- H-post anchor included
- Material: Nordic spruce
- Colour-treated in light oak
Photo gallery
Any carports, colour treatment and decoration shown are not included in the scope of delivery. These are customer photos, which are intended to give you an impression of the installed state.
Construction
The construction is made of solid Nordic fir. We use technically-dried, solid spruce wood, scanned for flaws, sorted and weatherproofed by finger-joint bonding according to length. Small fissures, branches and slight twists reflect the character of the materials used.
Colour treatment
The colour-treated components are coated with a layer of paint at the factory. The coating allows the natural wood grain to remain visible whilst ensuring a uniform surface finish. The components are coated on all sides twice at the factory, after which any excess material is brushed off.
Thanks to this factory pre-treatment, the components can be assembled immediately upon delivery. A primer coat prior to assembly is not required. Each kit also includes a quantity of wood stain or paint for touching up cut edges, screw holes or any damage caused during assembly. These areas should be treated in accordance with the installation instructions.
For a personalised finish, the visible wooden surfaces can be lightly sanded after assembly and treated with a suitable wood stain or paint. Components that have been colour-treated on all sides may show storage marks due to technical reasons.
- incl. installation post and post anchor
- 352 x 180 cm
- Spruce, colour-treated in light oak
- incl. installation post with post anchor