SKAN HOLZ Namur log cabin
- Dimensions 690 x 250 cm
- Colour: slate grey
- Enclosed space 260 x 250 cm
- Side canopy 267 x 250 cm with backwall and balustrade (can be fitted on the left or right)
- Side canopy 163 x 250 cm with slatted walls
- Made from Nordic spruce timber
- 4-side planed 28 mm wall logs with tongue and groove
- Bolted corner connection
- Floor 19 mm including impregnated ground supports
- Door with real glass and fitted glazing bars (glazing bar frames can be fitted or omitted as required)
- Moulded cylinder lock with 3 keys
- Door clear opening door w x h 78.5 x 179.5 cm
- Roof: 19 mm profiled cladding with tongue and groove
- Due to low roof pitch, roofing with shingles not possible (KSK-M roofing membranes are optionally available)
Construction
The construction is made of solid Nordic fir. We use technically-dried, solid spruce wood, scanned for flaws, sorted and weatherproofed by finger-joint bonding according to length. Small fissures, branches and slight twists reflect the character of the materials used.
Colour treatment
The colour-treated parts of the kit have been treated with paint. This protects the wood from blue stain and damage caused by UV light, reduces swelling and shrinkage, whilst still allowing the wood grain to show through. The log planks and corner strips are spray-coated twice on one side at the factory. The doors and windows are coated once on one side, whilst the roof fascia boards are coated twice on all sides. The inner surfaces of the log planks, doors and windows are untreated. The cut edges of the planks, the floor, the roof boarding and the purlins are also untreated. Each kit comes with a supply of paint or wood stain for repairs; use this to treat any damage or cut and screw joints required for assembly at least twice. All untreated parts of the kit fitted to the exterior (e.g. the undersides of the roof projecting outwards, roof purlins, the underside of the floor and the inside surfaces of the windows and doors) are unprotected and must be treated on site with a primer and two coats of glaze or paint. If you wish to give the surface an additional finish, lightly sand the visible surfaces after assembly and coat them with a high-quality wood stain. Please use our optional range of paints and wood stains for this purpose. Printed colour samples are not binding; colour variations may occur.
Walls
All 28 mm-thick wall logs have a single groove and tongue milling. The logs are inserted into one another and slotted and screwed into the corner post.
Roofing
The roof consists of 19 mm roof boarding. Roofing with shingles is not possible due to the low roof pitch. We recommend roofing with KSK-M roofing membrane (optionally available). The slope runs toward the rear.
Flooring
The floor consists of untreated 19 mm floorboards with tongue and groove, including impregnated ground supports.
- Enclosed space 260 x 250 cm
- Two side canopies
- Made from Nordic spruce
- 28 mm wall thickness
- bolted corner connection
