SKAN HOLZ Rhombus Back Panel for Carports
The Rhombus rear panel from SKAN HOLZ is a practical and visually appealing addition to selected carports. It provides additional privacy and gives the carport a modern, open rhombus design. The panel is constructed from individual rhombus-shaped profile strips, which are fitted between the existing posts.
The product is available in various sizes and colour options and can be selected to match the specific carport. Made from Nordic spruce, the back panel impresses with its natural appearance and solid workmanship.
Product features
- Rhombus rear panel for retrofitting or adding to selected SKAN HOLZ carports
- Available in various sizes and colour finishes
- Modern rhombus design with an airy look
- Comprises individual rhombus-shaped profile strips to be screwed between the posts
- Made from Nordic spruce
- Provides additional privacy and wind protection
- Complements the harmonious overall look of the carport
Contents
- Rhombus-shaped profile strips 2.8 x 5.6 cm
- Posts 12 x 12 cm
- 60 cm H-post anchors made of galvanised flat steel for embedding in point foundations to be provided on site
- Assembly materials
Notes
Any carports, colour finishes, accessories or decorative items shown are not included in the scope of delivery. Illustrations may show examples of use and are intended to illustrate the assembled state. The scope of delivery is determined by the specific product variant selected.
Construction
The construction is made of solid Nordic fir. We use technically-dried, solid spruce wood, scanned for flaws, sorted and weatherproofed by finger-joint bonding according to length. Small fissures, branches and slight twists reflect the character of the materials used.
Colour treatment
The colour-treated components are coated with a layer of paint at the factory. The coating allows the natural wood grain to remain visible whilst ensuring a uniform surface finish. The components are coated on all sides twice at the factory, after which any excess material is brushed off.
Thanks to this factory pre-treatment, the components can be assembled immediately upon delivery. A primer coat prior to assembly is not required. Each kit also includes a quantity of wood stain or paint for touching up cut edges, screw holes or any damage caused during assembly. These areas should be treated in accordance with the installation instructions.
For a personalised finish, the visible wooden surfaces can be lightly sanded after assembly and treated with a suitable wood stain or paint. Components that have been colour-treated on all sides may show storage marks due to technical reasons.
- Backwall Rhombus
- Suitable for post spacing of 550 cm
- Nordic spruce
- Colour-treated in anthracite
- Provides additional privacy and protection from the wind